Sports FAQ
Home / Badminton

Steps in order to badminton racket threading diagram

726.39718 million2010-02-02 21:01:49 +0000 #1
does not know how to Start
Ziyun Xiao 20092010-02-02 21:04:15 +0000 #2
1, vertical line up to the mid-point of the first film (from the one hole penetration), the difference on both sides of the order to wear a pull when the piercing the next nine holes, you must skip to the next 12 holes and then penetrate (during which a total of two lines jump holes), in the last 11 holes falling, and then from the 10 holes penetrated, from the next 10 holes falling, jump back to the next 8-hole penetration knot, ending a vertical bar, pull the work. Special Note: The vertical line 10 will be the last to pull the vertical line, rather than vertical line 11.

2, horizontal line should be knotted in the last six holes after starting from the seven holes penetrated pull, turn to the box at the end of each wearing a pull-up to wear clothing with only the next nine holes, from the next seven holes penetrated knot, thereby end of the horizontal line of pull of work.

3, the scope of the racket tension sleeve is a vertical tension requirements. When the pull horizontal line, the tension in the vertical line on the basis of 2 pounds or 10% increase in tension.

4, must be horizontal, vertical separation of pulling: pull vertical line, we should begin by the mid-point of the first film, respectively, to both sides of the balance of pull (which means that the simultaneous use of clip), to ensure that both sides of the racket about the same deformation, elastic symmetry, and pay attention to the jumper at the end of two vertical rules and pull direction; horizontal line from the box, then start from scratch, one by one to the box at the end of pull. Horizontal line tension should be higher than a vertical bar about 2 pounds.
sztent20092010-02-02 21:18:01 +0000 #3
this plan a detailed description of

Reply

Name:
Content:


Other posts in this category