Sports FAQ
Home / Tennis

Which is more suitable substrate table tennis

hoffcn20002010-02-11 01:02:06 +0000 #1
previously been used in a thinner floor, adding 3 Provincial mad, pull the ball sights on proficiency, but the control poor,

therefore, was to enhance the acquisition of a Yasaka Ma Lin Carbon 7 +2 layer of horizontal boards, at the end of Jin is enough, because a heavier bottom,

backhand chose the lesser Jin Koujiao ButterFly Sriver FX pull the ball are good defensive block shot,

being configured mad three provinces, Tian Ji 2, Tian Ji 3, G666 are tried to adapt to the 5 months,

is always being no way to adapt to, the key point is: not enough time friction, the ball went out, and

being too much worse than before, with the thinner floor before the positive hand is really worlds apart,

decided to dispose of, replace the floor,

I play is: being close to the table grab pull loop the ball, the backhand push after pulling the ball.

Tried STIGA CL-CR, too, abandoned, STIGA EG, control bad, dumped more than Nike Ao Chalov

6.2-6.4 thickness will be a good choice?

Some people say that mad Biao Wang, but the thickness of only 5.5, the control bar should be less capable.

Ask masters: According to my situation, floor to replace what brand, what model is good,

sets of plastic choices are mostly backhand ButterFly Sriver FX / EL

is in hand to the provincial mad 3, Tian Ji 2, Tian Ji 3, G666 can be ,

in this Thank you very much! ! !


_ Diablo _2010-02-11 01:17:01 +0000 #2
thin bottom is not difficult to control, but more hand shock. Louzhu should try YEO, better controlled than the Ma Lin Carbon is also easy to Tuidang. Selection of the most flexible set of rubber hardness of 39 degrees.
What strong and2010-02-11 01:20:21 +0000 #3
I would also recommend YEO fail, they give up tall and straight and then try using that Alpha is Hussein
steel wall Sport2010-02-11 01:41:46 +0000 #4
Hurricane Wang's control is very good, strongly recommended!

Reply

Name:
Content:


Other posts in this category